Extend the Lifeline of Your Hot Water Systems‎ Using Simple Steps
Electrical

Extend the Lifeline of Your Hot Water Systems‎ Using Simple Steps

Geysers are quite common these days and these forms basic option under the home comfort routine. But, just like with any other electrical item, hot water systems are in need of regular maintenance and diligent servicing if you want the item to last for a longer span of time. For procuring maximum longevity of the water heater, you have to work hard towards its maintenance.

A water heating tank is known to house around 40 to 80 gallon of water in the cauldron, which can heat and then store hot water until you need it for your use. As hot water gets to leave the tank, cold water is then piped right into the top of the tank. There are some dip tube channels available, which will pass water to the bottom of the tank and separated from hot water. Then the cold water gets heated at the bottom of the cauldron by electric element or gas burner.

Normally hot water can last up to 8 to 12 years, but you can increase its life by following below given points.

Some of The Trouble Signs Under Leaky Section:

You might have to head towards maintenance when you see a leak at bottom of hot water systems. It clearly indicates that the interior of the tank has been rusted and deteriorated to point from where there is no return at all. At that point, you have no other option but to purchase a new one in its place. You should end up purchasing a new one just to avoid around 40 to 80 gallons of water from spilling right into your room from the toilet due to a rupture.

Remember that the pressure relief valve relieves pressure inside the hot water systems, which helps in preventing any form of rupture later. In case the PRV is leaking hard, the time has come to call an emergency plumber for help and get the area checked out for good.

Heading Towards Water Impurities:

Water impurities are rather common and that can distort taste, color, and the smell of water. It even has the power to destroy hot water systems from inside. Discolored water is sure giveaway that the heater has to be repaired or flushed. As the water starts to heat up, minerals and sediments get separated from water and sink right at bottom of the tank or are attracted towards anode rod. If this rod goes bad or tanks are not flushed regularly, impurities start to accommodate, hindering the heating efficiency level and creating unpleasant crackling noises.

Areas to Check In:

The next time you are planning to purchase hot water systems, make sure to list out the areas of the tank that you have to check from one time to another. The steps are going to help you in big ways possible.

  • You have to check out the anode rods. These anode rods are constructed of magnesium or aluminum as formed around steel wire. They will always help in preventing hot water tank from getting rusted and changing when the steel wire is showing. You should switch off electricity every time when you check anode rod so that you will not get in danger.
  • Make sure to take some time out from the busy schedule to check out the dip tube. These tubes will direct incoming cold water to the base of the heater for getting it warmed up. Not all models will have them but make sure to check for the ones, which already have.
  • Don’t forget to flush down the water in the water heater on a yearly basis. You could ask experts to help you with that and don’t have to work on your own towards the hot water systems at all. It helps in washing out all sediment as build up in the tank.

These areas are a must-have for you to try out and work on. If you want to know more about the sessions, log online and get help.

You may also like...